Insulating the walls of your house this winter is extremely alluring to Thermique, as the main benefit of doing so is saving on the energy bills and adding value to their home.
The primary grant relating to home insulation which is available with the Sustainable Energy Authority of Ireland (SEAI) is the Home Energy Saving (HES) scheme. Homeowners can take advantage of this grant if they would like to spend money on enhancing the energy efficiency of their dwellings through insulating the walls of your home.
The year if the house was constructed will most likely determine the type of insulation required. In the event the house was built since 1920, your house will probably have cavity walls and almost certainly, if the house was built after 1950. Solid walls would be the other main construct of the home.
Cavity Walls could have two skins of brick, or one brick then one concrete block, having a gap in between, where air circulates and thus prevents water penetration. By insulting this gap will prevent air circulation, trapping the air and thereby stopping heat loss by as much as 65 per cent.
Insulating cavity walls, however, requires every exterior wall to become treated concurrently. Therefore, it is most effective from the cost viewpoint for homes which can be heated throughout long periods. This type of insulation will not be practical for any block of apartments, unless the complete building has been insulated simultaneously.
For cavity walls, there are 2 main home insulation methods what are the dry method and the foam method.
The dry method utilises mineral-wool fibres or expanded polystyrene beads blown through holes drilled on the outer top of the wall till the cavity is filled and insulation is complete. This method also ensures the optimum use of materials used.
The foam method can be produced on location and pumped with the holes burrowed on the outside wall. The foam dries after a few days and solidifies, and it should be famous for timber-framed homes.
Solid walls can be insulated in a different way, by either insulting the outside of the walls or line the interior top of the wall. These two methods can lead to the joinery, electrical and plumbing supplies being affected.
Another downside of the method is it is extremely expensive and may modify the visage of the building involved. This is caused as the cladding required on the exterior wall is definitely an elaborate process, affecting pipes, windows wcuiuh doors. These functions may need to be repositioned to accommodate the insulation.
By lining the interior wall, skirting boards, picture rails, architraves, lights, sockets and radiators may be affected and will need to be repositioned as a consequence. Utilizing a thermal board can be used to insulate the interior wall also by fixing the boards to battens. This can be done by attaching the thermal board direct towards the walls using a board recommended adhesive, having an additional fixing of screws to hold the thermals boards set up.